Includes rails! 1mm or .040 Thick 4130 Material. Top Rail Bent, Stepped and Trimmed
|
AK-Builder Flat Bending Die Set 1mm or .040" Punch. All of the flats we sell are 1mm and correct for this Die
|
These high quality flats were designed by AK-Builder to be as precise/mil spec as possible. Top Rail Bent, Stepped and Trimmed
|
Bent AK-74 Receiver Blanks Kit - 80% Complete
Originally made for Polish Tantal due to location of Selector Lever embossing. It is .200" lower than a standard selector embossing, but still functions correctly.
5.45 x 39mm
MADE IN POLAND
|
Original Imported Radom made AKM/AKMS Inner Receiver Rails - Made in Poland.
|
This is not a complete receiver and complies with all BATFE regulations. No FFL Required.
This is a New Polish Made receiver blank in the white with magwell, grip screw opening and trigger opening is cut. Works with all 1mm stamped AK47 kits
|
These are made from heat treated 4130 steel and the rivets are a copy of an original AK center support rivet. The length is shorter than the 1mm center supports since the inside of the 1.5mm flats is smaller
|
These high quality flats were designed by AK-Builder to be as precise/mil spec as possible. Top Rail Bent, Stepped and Trimmed
|
This flat was made for the Bulgarian style sidefolding triangle or polymer stock. The magwell and magwell dimples are made to fit 5.45 magazines.
|
AMD-65 Flat w/ rails from AK-Builder
|
This flat will work with the M92 or M70 that has the flat sided front trunnion. These will NOT WORK with the bulged RPK style trunnions. There aren't many that have the flat sided front trunnion, but there are a few out there.
|
This blank is in the white it has the magwell, grip screw opening and trigger opening is cut. There are no holes for the trunnions, axis pins, or selector. No receiver rails.
Made In Poland NEW
No FFL required
|
This blank is in the white it has the magwell, grip screw opening and trigger opening is cut. There are no holes for the trunnions, axis pins, or selector. No receiver rails.
Made In Poland NEW
This is not a complete receiver and complies with all B
|
AK-Builder Polish AKM 47 Underfolder Flat w/ rails
|
These are not needed on the Yugo's unless you aren't using the original pistol grip mounting plate. This plate welds to the rear lower section of the receiver to strengthen that area when using folding stocks. As shown it is set-up for an underfolder. The
|
This plate welds to the rear lower section of the receiver to strengthen that area when using folding stocks. The bend is in the right spot and not touching the hole so there are not fitting issues.
This plate was used on the Russian and Bulgarian
s
|
Safety Selector Plate-$9.99
|
* Designed for Combat Use with Great Zero Retention Feature
* Fits Both Milled and Stamped Receivers
* Accepts A Wide Variety of AK Side Mounts
* Consult with Machinist or Gunsmith for Quick Installation
|
This is the 1.5mm 4130 flat and rails for the M85 kits that are out. It's basically just our standard M70 underfolder flat without the pin holes cut for the recoil assembly locking pin. The center support will have to be clearanced to fit the .223 m
| | |