These are produced by a modernized arms factory in Poland that focuses specifically on high end Military grade parts. Looking for a true brand new 7.62x39 mil spec bolt? These bolts are fully machined from forged steel just like the original military soviet era produced bolts. Thanks to modern technology the specs are even better! Works in all Euro AK & AKM 47's in both semi and full auto mode!
Unlike any other new production AK bolts currently being sold WBP checks these bolts for 58 proper dimensions using the Zeiss CMM
* Anytime you install a new bolt into a firearm it is always a good idea to check headspace before operating or allow a qualified gunsmith to check it. It is possible this bolt will require minor fitting to one of the lugs before it will lock into battery depending on the rifle. When these rifles are built the bolt lug is typically hand fitted to each rifle at the factory and WBP has removed a small amount from the necessary bolt lug so it will work with most rifles without adjustment. But it is still possible you will need to do some additional fitment
Wytwórnia Broni Jacek Popiński (WBP)
Wytwórnia Broni Jacek Popiński (WBP)
Wytwórnia Broni Jacek Popiński (WBP)
Wytwórnia Broni Jacek Popiński (WBP)
Wytwórnia Broni Jacek Popiński (WBP)
Wytwórnia Broni Jacek Popiński (WBP)
Replaced an old worn bolt, this new bolt headspaced perfectly to a wasr. Machining and quality is superb.
Dropped right into my C 39
This bolt functions perfectly, quality made
Machining is perfect also the guide ramp has been pre adjusted to match the ramp on the bullet guide. No burrs either and finish is good as well.
new and quality at a great price and better than a possible iffy used part when building a top quality build .
Fit perfectly in a PSAK GF3 bolt carrier. Purchased as a spare, but may use for range time in place of the stock GF3 bolt.
I purchased the forged bolt and carrier. This review for the bolt. I haven't swapped out to try this new bolt but it is a new part, not surplus. It's complete with extractor, firing pin, and all springs and staking pins. It's complete.
Machining is good with no obvious large burrs or signs of a chipped out cutting tool when made like some other over seas manufacturers who never change endmills and parts have steps, gouges, and burrs all over bolt. This is nice looking. Though being a blackish color is a bit odd since the bolt carrier is a nickel chrome finish. Woulda thought the bolt would have been too since any color coating will wear off anyways.
Nice product. Great company.
Have not tested yet but compared to the one I have its better quality for sure!
