
Below are the available bulk discount rates for each individual item when you purchase a certain amount
These Polish 7.62x39 80% receiver blanks are 100% made in Poland using original Polish Radom Military tooling and parts. This is the closest you can get to an original military receiver! These 80 percent receivers already have both the rails and center support fully installed, and they are fully heat-treated with a black oxide finish. Polish selector markings are pre-stamped.
These are considered 80% complete so they do not require a FFL dealer since they are missing the axis pin and safety selector lever hole. We sell the AK-Builder blank drilling fixture to complete the last remaining holes.
These are 1.0 mm and work with all the AKM-47 parts kits we sell on the website!
We are not shipping these to NJ currently due to the ban on 80% receivers.
Great 80% only three stars because the rail could
Great 80% , only 3 stars because the rail were trimmed a little too short . I would prefer to trim the rails myself.
These receivers are fairly straight they hold the trunions well very easy for drilling however they do not have the trigger guard holes I thought that would be a turnoff but this is all they had left LOL I install my front trunnion install a magazine and then I take the magazine catch follower in the back the little piece and tape it down to the receiver in place with the magazine type then I remove the magazine and take a small drill bit that fits the whole well and a hand drill and I just put a little bit in the receiver to Mark the whole location after I do that it's just as good as a Childers anyway these are great and now they're gone thanks Biden
Bought many of these over the years. It was nice while it lasted. That’s what happens when you got a commie for a damn president! FJB!!!!
Good fit and finish ....GREAT PRODUCT !
Awesome value
I picked up one of these for a parts kit I have, and I must say the quality is pretty good! Thank you!
Great shape, oil, and as advertised
Excellent product as always from AOA!
These receivers are okay. I wish they had the sugar guard hold drills however. I would call these 70%. I figured a way to drill these holes you just use the magazine catch plate after you install the front end install a magazine and push that little plate up tight against the magazines where you desire to have it tape it in place then get a drill and go to town.