These Polish 7.62x39 80% receiver blanks are 100% made in Poland using original Polish Radom Military tooling and parts. This is the closest you can get to an original military receiver! These 80 percent receivers already have both the rails and center support fully installed, and they are fully heat-treated with a black oxide finish. Polish selector markings are pre-stamped.
These are considered 80% complete so they do not require a FFL dealer since they are missing the axis pin and safety selector lever hole.
These are 1.0 mm and work with all the AKM-47 parts kits we sell on the website!
We are not shipping these to NJ currently due to the ban on 80% receivers.
-
Receiver
Works great, very precise built, quality built, fast shipping
-
Polish 80% receiver
Very good quality and speedy shipping. Will definitely be getting more of these
-
Receiver
Works great, good quality,
-
WPB Polish Radom AKM 7.62 x 39 80% Receiver Blank
Haven't finished blank or assembled the AK yet. Initial assessment is that they are high-quality. Looking forward to using them. Should be part of an awesome build.
-
WBP POLISH RADOM AKM 7.62X39 80% RECEIVER BLANK
These are great. Do your part correctly and you will have no problem with assembly. A little extra work drilling trigger guard holes. Not a problem. Get some before you can't.
-
80% Blank
These blanks are good for any build kits that you use. Will surely buy more.
-
Excellent well made polish receivers
These arrived on time in excellent condition I will buy them again when you get more in stock
-
WBP POLISH RADOM AKM 7.62X39 80% RECEIVER BLANK
Excellent quality, fast shipping and completely satisfied as always from Arms Of America, What else can I say? You won't go wrong with their parts and service!
-
Receiver blank
gold standard. not much else needs to be said.
-
80%
Great 80% only three stars because the rail could
Great 80% , only 3 stars because the rail were trimmed a little too short . I would prefer to trim the rails myself.
-
Receiver 80%
These receivers are fairly straight they hold the trunions well very easy for drilling however they do not have the trigger guard holes I thought that would be a turnoff but this is all they had left LOL I install my front trunnion install a magazine and then I take the magazine catch follower in the back the little piece and tape it down to the receiver in place with the magazine type then I remove the magazine and take a small drill bit that fits the whole well and a hand drill and I just put a little bit in the receiver to Mark the whole location after I do that it's just as good as a Childers anyway these are great and now they're gone thanks Biden
-
Polish 80% AKM receiver
Bought many of these over the years. It was nice while it lasted. That’s what happens when you got a commie for a damn president! FJB!!!!
